I have a question about the output report for a steel structure in XFEM4U 2027.2 (but also in the previous versions).
In the output selection tab I choose to print the maximum u.c. for each profile so at the end of the table of EN1993 CHECKS I see the beam with the maximum values of usage coefficient and the calculation of unity checks for that beam in the next paragraph.
If the deflection u.c. is higher than a “structural” one, then in the calculation of unity check I see only the checks for that beam. Is there a setting to separate the two checks and show the calculation for both the most deflection-critical beam and the most structurally critical one?
Thanks